Roll forming · Door & frame profiles · B2B supply
Roll forming and punching equipment for steel door frames, jambs and associated profiles. Hinge cut-outs, strike plate recesses and anchor holes are integrated in-line to remove secondary operations.
Request a quotation → Explore all equipment01 / CAPABILITY
Tooling developed from your jamb section and stop detail.
02 / CAPABILITY
Hinge, latch and anchor holes punched to the approved pattern.
03 / CAPABILITY
Cut length and end condition controlled for welded or knock-down assembly.
04 / CAPABILITY
Recipe-based setup for multiple frame depths and widths.
| Item | How it is defined |
|---|---|
| Coil material | Cold rolled, galvanised or pre-painted steel strip |
| Frame section | Configured to your door frame drawing |
| Punching | Hinge / latch / anchor pattern set by tooling drawing |
| Cut length | PLC-controlled, tolerance agreed before build |
| Line control | PLC + HMI with recipe storage and output counter |
| Options | Coil car, leveller, marking, automatic stacking |
Indicative scope only. Final dimensions, capacities and tolerances are confirmed in the layout drawing and proposal for your project.
01 / DRAWING REVIEW
Send your profile drawing, tank specification or capacity target. Our engineers check material, tolerances and upstream / downstream interfaces.
02 / LAYOUT & QUOTATION
You receive a line layout, equipment list, utility requirements and a budget quotation. Nothing is manufactured before you approve the scope.
03 / BUILD & FACTORY TEST
Equipment is built and dry-run in our workshop. Test records, spare parts list and documentation are prepared for your review.
04 / INSTALL & SUPPORT
On-site installation, operator training and remote after-sales support, with consumables and wear parts available for the life of the line.
Send your drawing, capacity target or market specification. Our engineers will return a layout, equipment list and budget quotation.
Request a project quotation →